Processing Errors - Ricoh FT8880 Service Manual

6 March 1992

4.3 PROCESSING ERRORS

Reference Line
If the reference line does not reach the mark detection sensor within 2.6
seconds after the job sheet is fed in, the job sheet is fed out. (Feeding out
takes 1.6 seconds.) The red light blinks for 6 seconds; then, the job sheet
can be reinserted.
Reference Mark
If the mark detection sensor detects the reference line and then fails to detect
a reference mark within 0.2 seconds, or if it fails to detect a reference mark
within 0.1 seconds, the job sheet is fed out and the red light blinks for 6
seconds; then, the job sheet can be reinserted.
NOTE: Occasionally, the job sheet feeds out to the rear side of the menu
reader after a failure to detect the reference mark number.
Marking
When two or more selections are made for the same item, the menu reader
cannot process the job sheet and the red light blinks (indicating an error).
NOTE: 1. When an item is not marked on the job sheet, the menu reader
automatically reads as follows:
2. The job sheet may jam inside the menu reader if it is smaller
than the specified size.
CAUTION: Sensors were set at the factory and cannot be adjusted in
the field.
-- Item --
Copy Quantity
Reproduction Ration
-- Indicator --
1
100%
7
BASIC OPERATION