Led Table - Ricoh FT8880 Service Manual

5 June 1992

4.3 LED TABLE

LED No.
Main PCB
LED 1
LED 2
LED 3
LED 4
LED 5
LED 6
LED 7
LED 8
LED 9
LED 10
LED 11
LED 12
LED 13
LED 14
LED 15
LED 16
LED 17
LED 18
Transport Drive Motor Control PCB
LED 1
NOTE: In SP mode, the transport drive motor, stack feed motor, and exit
drive motor speeds are adjusted automatically in order. While each
motor is adjusted, if the motor speed is normal, LED17 and LED18
light. If the motor speed is too high, only LED17 lights. If the motor
speed is too low, only LED18 lights.
Stack feed-out belt H.P sensor is not actuated.
Jogger unit connector is not completely set.
Stapler H.P. sensor is actuated.
Jogger H.P. sensor is actuated.
Jogger unit paper sensor is activated.
Jogger unit entrance sensor detects the paper.
Shift tray lower limit sensor is actuated.
Stack height sensor 2 is actuated.
Exit unit H.P. sensor is actuated.
Exit unit half turn sensor is not actuated.
Stack height sensor 1 is actuated.
Shift tray half turn sensor is actuated.
Exit sensor is detects the paper.
Entrance sensor is activated.
Hammer H.P. sensor detects hammer.
Staple end sensor is activated.
OFF: Motor speed is too low.
OFF: Motor speed is too high. Note
Transport drive motor speed is normal.
23
ON Status
Note
SERVICE TABLES