Ricoh FT8880 Service Manual page 38

5 June 1992
[B]
[F]
[H]
[G]
10. Remove the charge corona unit [A] (1 connector and 1 clamp) and erase
unit [B].
11. Lower the transport unit by the lever [C] as shown and remove the drum
stay [D] and cleaning unit [E].
12. Remove the drum potential sensor [F] (2 connectors), ID sensor [G], and
drum protection sleeve [H].
13. Reinstall all the units around the drum except for the development unit
and PTC unit.
NOTE: Press the drum shaft [I] to the left and align the cleaning unit to
[A]
[I]
[E]
the guides [J] to prevent the drum damage when reinstalling the
cleaning unit.
INSTALLATION PROCEDURE
[D]
[J]
3-7
[C]