Table of Contents
Advertisement
HOT ROLLER REPLACEMENT
9.8 HOT ROLLER REPLACEMENT
1. Remove the fusing lamp (see Fusing Lamp Replacement).
2. Remove the hot roller stripper pawl bracket (see the Hot Roller Stripper Pawl
Removal).
3. Remove the screws [A] and swing down the pressure levers [B], then remove
the pressure springs [C].
4. Remove the gear [D] (1 E-ring).
5. Remove the hot roller [E] (2 C-rings, 1 gear, 2 bushings, 2 bearings).
NOTE: 1) Before installing the hot roller, peel off 3 mm (1 inch) from both ends of
the protective sheet on the new one.
2) The standard pressure spring position is at the upper position.
3) Do not touch the surface of the roller.
4) Be careful not to damage the surface of the hot roller.
All manuals and user guides at all-guides.com
[E]
[A]
[B]
[C]
50
14 August 1997
[D]
[B]
[A]
[C]
A217R518.cdr
Advertisement
Table of Contents
