INSTALLATION PROCEDURE
3.2 KEY COUNTER HOLDER INSTALLATION
CAUTION: Unplug the copier power cord before starting the following
procedure.
1. Open the right front door and remove the right inner cover (3 screws).
2. Remove the dummy connector [A].
3. Remove the right cover [B] (2 screws) and small cap [C].
4. Connect the key counter holder [D] to key counter bracket [E] with key
counter plate nut [F] (2 screws).
5. Run the key counter harness [G] through the bushing [H] and right cover
hole [I] and fix the key counter harness (1 screw and 1 harness clamp).
6. Install the key counter bracket to the right cover (3 screws).
7. Set the key counter harness connector to the 4P connector from the
copier.
8. Reinstall the right cover.
9. Install the key counter cover [J] (2 screws).
10. Reassemble the machine.
[B]
[A]
3-14
5 June 1992
[I]
[C]
[E]
[J]
[D]
[H]
[F]
[G]