Ricoh FT8880 Service Manual page 140

5 June 1992
[A]
11. Open the finisher front door and install the staple cartridge (refer to the
instruction decal on the rear side of the front door):
a) Pull out the transport unit [A].
b) Release the lock lever [B] and turn the stapler counterclockwise until it
locks.
c) Remove the green plastic clip [C] from the staple cartridge, and install
the cartridge in the stapler.
d) Set the stapler to its original position.
e) Push the transport unit in its original position.
12. Plug in the power cord and turn on the copier main switch.
13. Test the operation of the finisher.
NOTE: The stapler will not be stapling for the first 10 or so copies until
the first staple comes to the proper position from the cartridge.
[B]
21
INSTALLATION
[C]