Ricoh FT8880 Service Manual page 37

INSTALLATION PROCEDURE
[I]
[D]
[A]
[B]
[K]
[M]
[J]
6. Remove the front scale holder [A] (2 screws), front scale [B] (2 screws),
exposure glass [C], left top cover [D] (7 screws), and right rear cover [E]
(front view, 2 screws).
7. Remove the 3rd scanner fixing bracket [F] (1 screw) and scanner fixing
screw [G].
NOTE: The scanner fixing screw is required when replacing the scanner
wire. Please keep it for future use.
8. Reinstall the exposure glass, front scale, front scale holder, and the left
top cover.
NOTE: The mark [H] on the edge of the glass should face up. This
•
side is smoother and it generates less static electricity when
the DF is used.
Use the flat head screw for 4 screws [I].
•
9. Remove the left inner cover [J] (4 screws), strip of filament tape [K]. Then,
remove the PTC unit [L], and the development unit [M] (1 screw and 1
connector).
[C] [H]
[E]
[L]
3-6
[F]
5 June 1992
[G]