Ricoh FT8880 Service Manual page 39

INSTALLATION PROCEDURE
14. Remove the development filter [A] from the development unit.
15. Pour the developer (1 bag: 1.7 kg) evenly between the left and right side
of the development unit and reinstall the development filter. Then,
reinstall the development unit (1 connector and 1 screw), and PTC unit on
the copier.
16. Load toner as follows (refer to the instruction decal):
a) Shake a new toner cartridge well while holding it horizontally.
b) Turn the green lever clockwise.
c) Insert the cartridge and return the green lever to the down position.
d) Cut the green tape.
e) Press down tab 1 and pull shutter 2 until you see the green tab 3.
f) Grasp tab 3 and pull the seal until you see the red line.
g) Push the shutter back in.
17. Install the left inner cover and set the transport unit.
[A]
3-8
5 June 1992