Transport Belt Replacement - Ricoh FT8880 Service Manual

5 June 1992
13. RDH

13.1 TRANSPORT BELT REPLACEMENT

[H]
[E]
[C]
1. Release the belt unit [A] by sliding the belt release lever [B] to the right.
2. Loosen the screw [C] and slide the lever [D] supporting the left transport
belt unit [E] to the right.
3. Remove the support guide plate [F] (2 screws).
4. Fold down the transport belt to the release position, and replace the
transport belt [G].
NOTE: When replacing the transport belt, make sure the transport belt is
positioned under the ribs [H].
[F]
[D]
5-1
[B]
[G]
[H]
RDH
[A]