Table of Contents
Advertisement
REPLACEMENT AND ADJUSTMENT
11.7 HOT ROLLER REPLACEMENT
[A]
[F]
[G]
[H]
[I]
[J]
1. Remove the exit unit. (See Exit Unit Removal of the A110/A111 copier.)
2. Remove the fusing lamp. (See Fusing Lamp Replacement of the
A110/A111 copier.)
3. Remove the exit paper guide (1 screw).
4. Remove the front and rear pressure springs [A].
5. Remove the C-ring [B] (front side).
6. Remove the 2 screws [C] securing the bearing to the fusing front frame,
then remove the bearing [D] and spacer [E].
7. Remove the rear C-ring [F].
8. Slide the hot roller out. The gear [G] will drop off the hot roller shaft.
9. Replace the hot roller [J] (1 bearing [H] and 1 spacer [I]).
[A]
40
31 March 1994
[C]
[E]
[D]
[B]
Advertisement
Table of Contents
