Ricoh FT8880 Service Manual page 150

5 June 1992
5.5 JOGGER DRIVE BELT REPLACEMENT
[G]
[B]
1. Open the front door and slide out the staple unit [A].
2. Remove the front and rear jogger fences [B] (2 screws each).
3. Remove the 2 screws [C] fixing the jogger fence sliders [D] to the belt
clampers [E].
4. Mark the position of the tension bracket [F] and remove (1 screw).
5. Remove the jogger drive belt [G] with the belt clampers [C].
NOTE: When reassembling, put the bracket [F] back to the marked
position.
[C]
31
REPLACEMENT AND ADJUSTMENT
[E]
[F]
[D]
[A]