Ricoh FT8880 Service Manual page 36

5 June 1992
[A]
[E]
[D]
3. Remove the fusing cover [A] (3 screws), fixing bracket [B] (1 screw), and
reinstall the fusing cover. Install the fusing unit release lever [C], turn the
lever clockwise, and fix it (1 M5 x 8 screw).
4. Pull out the duplex unit [D], open the upper guide [E], and remove the
strip of the filament tape [F]. Reset the duplex unit.
NOTE: Do not pull duplex fork gate from positioning pin when removing
filament tape.
5. Remove the right cover [G] (2 screws) and 1 stud [H] securing the paper
tray. Reinstall the right cover.
[B]
[H]
3-5
INSTALLATION PROCEDURE
[G]
[C]
[F]