Ricoh FT8880 Service Manual page 85

RDH
13.2 FEED-IN BELT REPLACEMENT
[G]
[F]
[G]
NOTE: Take care not to damage the harnesses [A] of the original table by
pulling roughly.
The side-to-side registration of the paper stack mode is required
after removing and reinstalling the original table. Before removing,
mark the position of the original table position to allow easier
reassembling.
1. Remove the RDH front cover [B] (6 screws).
2. Disconnect the 3 connectors [C] and remove the original table [D] (4
screws), otherwise the harnesses could be damaged.
3. Disconnect the drive shaft joint [E] (2 allen screws).
4. Remove the feed-in belt unit [F] (4 screws and 2 connectors [G]).
5. Replace the feed-in belts [H].
•
NOTE:
•
[H]
The shiny side of the feed-in belts should face out.
When reassembling, pass the 3p connector through the hole [I]
and the 6p and 9p connectors through the slit [J].
[A]
[B]
[E]
5-2
5 June 1992
[D]
[J]
[I]
[C]