Ricoh FT8880 Service Manual page 86

5 June 1992
13.3 SIDE-TO-SIDE REGISTRATION ADJUSTMENT
1. Set an original on the original table and make a copy in the stack feed
mode.
2. Measure the difference of the side-to-side registration between the copy
and original.
3. If the value does not match the standard, loosen the 4 screws [A] to
change the original table position. Then, tighten the screws.
4. Make continuous copies to check the variation. If the variation does not
match the standard, repeat the above step.
[A]
5-3
RDH