Duress Code; To Change Your Master Code; Quick Arming; Phone (Voice) Module - ADEMCO Vista-10SEa User Manual

Hide thumbs Also See for Vista-10SEa:

Table of Contents

SECURITY CODES (cont)

Duress Code

– 12 –

www.PDF-Zoo.com

This feature is intended for use when you are forced to disarm or arm the

system under threat. When used, the system will act normally, but can

silently notify the central station of your situation, if that service has been

provided.

The Duress code is entered in the same manner as other codes, and is defined

as User No. 8.

IMPORTANT: This code is useful only when connected to a central

station.

Enter the original Master code + [8] + [2] + new Master code + new Master

code again.

The keypad will beep 3 times, indicating acceptance of the new Master code.

Ask your installer if "Quick Arming" is active for your system; if so, check

here:

If your system supports Quick Arming, the [#] key can be pressed in place of

the security code when arming the system. The security code is always

required, however, when disarming the system.

Ask your installer if your system includes a phone module; if so, check here:

If your system includes a phone module, your installer will have programmed

a 2-digit phone access code for your system. Be sure to obtain this phone code

from your installer.

Complete information regarding the use of this phone access feature is

provided in a separate manual entitled PHONE ACCESS USER'S GUIDE,

which accompanies the phone module.

Table of Contents