Slave Base Station Configuration - Avaya DECT R4 Installation Manual

8.5 Slave Base Station Configuration

The base station installation process consists of the following stages:
1.Default the base station.
2.Access the base station configuration.
3.Update the base station firmware.
4.Set the base station IP address.
5.Set the base station to slave mode.
6.Reset the base station.
7.Check the base stations.
DECT R4
IP Office Release 7.0
Non-Provisioned Installation: Master Base Station Configuration
15-601047 Issue 03a (21 February 2011)
Page 143