8.4.8 Set the Base Station as the Master
A number of menus are disabled until the base station has been set a being the master base station for the IP Office DECT
R4 system.
1. In the left-hand panel select DECT. Select the Master tab.
2. Use the Mode drop-down box to select Active.
3. Click OK.
4. Click on the Reset required! message.
5. Click OK.
6. In the left-hand panel select DECT. Select the System tab.
7. Set and check the following values:
DECT R4
IP Office Release 7.0
Non-Provisioned Installation: Master Base Station Configuration
15-601047 Issue 03a (21 February 2011)
Page 135