Replace The Aiws Cover; Aiws Status Lamp - Avaya DECT R4 Installation Manual

6.10 Replace the AIWS Cover

The AIWS cover can be clipped back into place without using any tools.
1. Check that the AIWS is fully operating (green lamp) and can be browsed from the network.
2. Check that the cables are routed such that they will not be trapped when the cover is replaced.
3. Engage the cover with the top edge of the AIWS. Pivot the cover back into position, checking that the various
plastic edges are in their original positions.
4. The cover clips will spring into position.

6.11 AIWS Status Lamp

Colour State
Green On
Orange On
Flashing (1 second on/off)
Fast flash (100ms on/off)
Intermittent flash (100ms on/1 second off)
Slow flash (2 seconds on/3 seconds off)
Wink (5 seconds on/100ms off)
Red On
Intermittent flash (100ms on/1 second off)
Flashing (1 second on/off)
Slow flash (2 seconds on/3 seconds off)
Very slow flash (3 seconds on/3 seconds off)
Wink (5 seconds on/100ms off)
DECT R4
IP Office Release 7.0
Description
Running.
Failsafe or Network setup mode.
Image installation mode.
Starting.
Restart.
Halted (auto restart after 10 minutes).
Unlicensed.
Low voltage.
License error.
Watch dog reset.
Shutdown.
Memory error
Network error/Module key error.
15-601047 Issue 03a (21 February 2011)
Page 114