3.4.6 Register the Slave Base Station
The slave base station needs to register and be synchronized with the master base station. This is done in the master base
station configuration.
1. Login to the master base station.
2. Select Device Overview and then select the Radios tab.
3. The new slave base station is shown as an unregistered device. Click on Add.
4. On the popup form that appears, click OK.
5. The slave base station will be listed as a registered device. It can take up to 2 minutes for the base station to
synchronize with the master base station. During this time its upper lamp will flash red and the status shows as Not
in sync . Once it is in synch, the upper lamp is extinguished and the status is shown as OK.
DECT R4
IP Office Release 7.0
Provisioned Installation: Slave Base Station Setup
15-601047 Issue 03a (21 February 2011)
Page 55