6.8 Switching Off the AIWS
Having now configured and upgraded the AIWS, it should be switched off and disconnected prior to being wall mounted
1. At the top right of the
2. Press the button until the AIWS lamp starts to flash orange.
3. Remove the power cable. The power must be removed within 10 minutes or the AIWS will restart. If the AIWS
restarts, wait until the Function Indicator is not indicating starting up (flashing orange) before pressing the SW4
button again.
6.9 Wall Mount the AIWS
The AIWS can be wall mounted. To facilitate service after the unit is installed, we recommend a free space of about 150
mm above and 50 mm below the unit.
DECT R4
IP Office Release 7.0
AIWS circuit board
, locate the SW4 push button.
98
AIWS Installation: Upgrade the AIWS Firmware
15-601047 Issue 03a (21 February 2011)
Page 113