Default The Base Station - Avaya DECT R4 Installation Manual

8.5.1 Default the Base Station

This process will default the base station, erasing its configuration. After the base station restarts it will default to the IP
address 192.168.0.1/255.255.255.0.
1. With the base station not connected to anything else, connect the power supply and switch on.
2. Wait approximately 5 seconds.
3. Using a fine point, depress the base station's reset switch for at least 10 seconds until the upper LED starts to flash
alternately green red.
4. Release the switch and then depress it again once rapidly.
5. The base station will restart.
6. After approximately 5 seconds the base station will default to the address 192.168.0.1.
Alternate Method
The address an existing base station is using can be determined using the following process. It uses the base stations MAC
address which is printed on the label on the back of the base station.
1. Open a Windows command window by selecting Start | Run and enter cmd.
2. Enter nbtstat -R. The PC should respond that is has purged and reloaded the NBT remote cache table.
3. Enter nbtstat -a ipbs-xx-xx-xx when xx-xx-xx is replaced with the last 6 hexadecimal digits of the base stations
MAC address.
4. The results will show IPBS-xx-xx-xx and the IP address which it is using.
4. Use that address to access the base stations configuration and set it to a fixed address.
DECT R4
IP Office Release 7.0
Non-Provisioned Installation: Slave Base Station Configuration
15-601047 Issue 03a (21 February 2011)
Page 145