Set The Base Station To Slave Mode - Avaya DECT R4 Installation Manual

8.5.5 Set the Base Station to Slave Mode

There can be only 1 master base station in the IP Office DECT R4 system. In this process we check that the base station is
not set to act as a master and then configure its radio settings to access the master base station.
1. In the left-hand column, select DECT. Select the Master tab.
2. Check that the Mode is set to Off.
3. Click OK.
4. Select the Radio tab.
5. Set the following details:
· Name
Set this to match the System Name set on the master base station's DECT | System tab.
· Password
Set this to match the Password set on the master base station's DECT | System tab.
· Master IP Address
Enter the IP address of the master base station set on its LAN | IP tab.
6. Click OK.
DECT R4
IP Office Release 7.0 15-601047 Issue 03a (21 February 2011)
Page 150