Qos/Tos Settings; Enable Status Logging - Avaya DECT R4 Installation Manual

8.4.6 QoS/ToS Settings

If the network uses QoS/ToS for VoIP traffic, the base station should be configured to use the same settings.
1. In the browser connection to the base station, in the left-hand panel select IP. Select the Settings tab.
2. Set the ToS Priority - RTP Data value to match the IP Office's DSCP (Hex) value.
3. Set the ToS Priority - VoIP Signalling value to match the IP Office's SIG DSCP (Hex) value.
4. Click OK.

8.4.7 Enable Status Logging

1. In the left-hand panel, select UNITE. Select the Status Log tab.
2. For the Unite IP Address, enter the IP address that will be assigned to the AIWS unit when installed in the DECT
system.
3. For the Unite Resource Identity enter a unique name to be associated with the base station.
4. Click OK.
DECT R4
IP Office Release 7.0 15-601047 Issue 03a (21 February 2011)
Page 134