Avaya DECT R4 Installation Manual page 127

Pre-Requisites
· o IP Office connected to the LAN with IP DECT line configured for master base station IP address.
Parts Required
· Base station
Includes:
· Base station.
· Two 3.5mm screws and two 6mm wall plugs suitable for wall mounting onto a solid wall (brick or similar).
· 1.2 metre (4 foot) LAN cable. If this is replaced with a longer cable the replacement should be a CAT5 Ethernet
LAN cable.
· If using Power over Ethernet:
· The base station supports Power over Ethernet, IEEE 802.3af, class 2.
· If not using Power over Ethernet:
· Base station power supply unit.
Required if not using Power over Ethernet to power the base station. Note that the base station power supply
units include an 8 metre (26 feet) cable from the PSU to the base station. Check that you have the correct type
of power supply unit for the locale.
· BSX-0013: Europe (except United Kingdom).
· BSX-0014: United Kingdom.
· BSX-0015: USA/Canada.
· BSX-0016: Australia.
· Mains power outlet socket.
· LAN Socket.
Information
· DECT R4 SARI.
· Base Station IP Addresses.
· Detailed plans from the site survey indicating the intended base station locations, LAN sockets and if necessary
power supply outlets.
Tools
· Programming PC with DECT R4 software.
· Web browser.
· Drill and drill bits suitable for the selected wall mounting position of the AIWS.
· Screwdrivers for use with the screws selected for AIWS wall mounting.
DECT R4
IP Office Release 7.0
Non-Provisioned Installation: Master Base Station Configuration
15-601047 Issue 03a (21 February 2011)
Page 127