Ip Dect Line Setup - Avaya DECT R4 Installation Manual

3.2.2 IP DECT Line Setup

At this stage we will create an IP DECT line for traffic between the IP Office and the DECT R4 system. The line is
configured with the IP address of the master base station. The IP Office configuration only requires and allows a single IP
DECT line.
· Reboot Required
Add or removing a line from the IP Office configuration requires the IP Office system to reboot. This will end all calls
and services in progress.
1. Using IP Office Manager, receive the configuration from the IP Office system.
2. Click on Line. The list of existing lines is shown.
3. Click on the icon and select IP DECT Line. The settings for an IP DECT line are displayed. If the option is greyed
out then the configuration already contains an IP DECT line.
4. On the Line tab there are no adjustable settings. Once the system is installed and operational, this tab will list the
DECT extensions.
5. Select the VoIP tab. This table is used to set details of the master base station.
a. Set the Gateway IP Address to match the IP address that will be assigned to the master base station. The
MAC Address field is not used.
b. Leave the other fields at their default settings.
DECT R4
IP Office Release 7.0 15-601047 Issue 03a (21 February 2011)
Page 34