Enable Provisioning - Avaya DECT R4 Installation Manual

3.3.10 Enable Provisioning

The master base station can now be configured for IP Office provisioning. Once this is enabled, several fields of the base
station configuration will be set by the IP Office system. Other fields are greyed out and or automatically set to the values
required for IP Office operation.
1. Select General and then select the Provisioning tab. This tab is only available when the base station's Master
setting is Active and the PBX setting is set to IPO (see
· Select the Enable option.
· The IP Office security settings
the master base station (by default it is supported).
· Set the PBX IP Address to match the IP Office system on which the IP DECT line was configured.
2. Click OK.
3. Reset the base station.
a. Select Reset and then select the Reset tab.
b. Click on OK.
c. Observing the base station, wait for the lower light to return to solid green.
4. Select the General | Provisioning tab again. The Status should have changed to Connected.
5. Select DECT | SARI. The value of the SARI entered into the IP Office configuration should now also be visible in the
base station configuration.
6. Select DECT | System. The message System in Provisioning Mode is shown. The Subscriptions mode is greyed out
and set to With System AC. The Authentication Code will match the one set in the IP Office configuration.
DECT R4
IP Office Release 7.0
Select Master Mode
control whether HTTPS is supported between the IP Office control unit and
32
).
45
15-601047 Issue 03a (21 February 2011)
Page 48