7. Select the Air Sync tab.
8. Set the Sync Mode to Slave.
9. Enable LED Indication. This enables the amber flashing mode of the base station's LED 2 which is used to indicate
when the base station has no air synchronization signal but does have call traffic in progress.
10.Click OK.
8.5.6 Reset the Base Station
1. In the left-hand panel, select Reset. Select the Reset tab or Idle-Reset tab.
2. Click OK.
DECT R4
IP Office Release 7.0
Non-Provisioned Installation: Slave Base Station Configuration
15-601047 Issue 03a (21 February 2011)
Page 151