Update The Base Station Firmware - Avaya DECT R4 Installation Manual

8.4.3 Update the Base Station Firmware

The base station may need to be upgraded to the software supplied for use with IP Office administration software. That
software consists of two parts, a firmware file and a boot file. All base stations in a DECT system should use the same
software.
1. Having browsed into the base station's configuration, note the software levels shown by the Version line.
· If they do not not match the versions in the IP Base Stations folder, then the base station should be
upgraded.
· If both software files need to be upgraded, the boot file should be upgraded first.
2. To upgrade the boot file, in the left-hand column select Update and then select the Boot tab. To upgrade the base
station file, select Update and then select the Firmware tab. The method for both files is similar, however ensure
you upgrade the boot file first if both need to be upgraded.
3. Click on the Choose File button and browse to the IP Base Station sub-folder of the IP DECT R4 software you
previously extracted onto the programming PC.
4. Select the appropriate file for the upgrade you are performing, ie. the file with boot in the file name if doing a boot
file upgrade. Click OK.
5. Click on the Upload button.
6. The browser will show the progress of the upload and firmware upgrade. It will indicate when the process has been
completed.
7. Click on immediate reset.
DECT R4
IP Office Release 7.0 15-601047 Issue 03a (21 February 2011)
Page 130