Rear Washer Nozzle Removal; Installation; Rear Wiper Arms Removal - Chrysler PT Cruiser Service & Repair Manual

8R - 14 WIPERS/WASHERS
FRONT WIPER SWITCH (Continued)
Fig. 16 MULTI-FUNCTION SWITCH - REMOVE/
1 - MULTI-FUNCTION SWITCH CONNECTOR
2 - HAZARD/WARNING SWITCH
3 - WINDSHIELD WIPER/WASHER SWITCH CONNECTOR
4 - MOUNTING SCREWS
5 - COMBINATION FLASHER
Fig. 17 FRONT WIPER SWITCH - REMOVE/INSTALL
1 - FRONT WIPER SWITCH
(3) Connect both posi-lock harness connectors at
the rear of the multi-function switch and front wiper/
washer switch (Fig. 16).
(4) Install both upper and lower steering column
shrouds (Refer to 19 - STEERING/COLUMN/UPPER
SHROUD - INSTALLATION).
(5) Connect the battery negative cable (Fig. 12).
(6) Close hood.
(7) Verify vehicle and system operation.
INSTALL
REAR WASHER NOZZLE
REMOVAL
(1) Open liftgate.
(2) Remove liftgate CHMSL access panel (Refer to
23 - BODY/DECKLID/HATCH/LIFTGATE/TAIL-
GATE/CHMSL COVER PANEL - REMOVAL).
(3) Disconnect the rear washer hose at nozzle.
(4) Remove the nut retaining the rear washer noz-
zle and remove the nozzle from rear window glass
and vehicle.

INSTALLATION

(1) Install the nozzle into rear window opening
and retaining nut to the rear washer nozzle and
torque to 2.8 N·m (25 in. lbs.).
NOTE: Verify that the nozzle is pointing straight
down.
(2) Connect the rear washer hose at nozzle.
(3) Install liftgate CHMSL access panel (Refer to
23 - BODY/DECKLID/HATCH/LIFTGATE/TAIL-
GATE/CHMSL COVER PANEL - INSTALLATION).
(4) Close liftgate.
(5) Verify vehicle and system operation.
REAR WIPER ARMS
REMOVAL
(1) Remove the rear wiper arm nut cap.
(2) Remove wiper arm retaining nut.
(3) Use a battery terminal puller to remove the
wiper arm from the wiper pivot (Fig. 18).
Fig. 18 WIPER ARM PULLER (SHOWN ON FRONT
WIPER ARM)
1 - WIPER ARM
2 - WIPER PIVOT
3 - BATTERY TERMINAL PULLER
PT