Courtesy/Reading Lamp Removal; Installation; Dome Lamp Removal; Dome Lamp Unit Removal - Chrysler PT Cruiser Service & Repair Manual

8L - 30 LAMPS/LIGHTING - INTERIOR
CENTER CONSOLE FLOOD LAMP HOUSING (Continued)
Fig. 2 LOWER INSTRUMENT PANEL CENTER
1 - CONSOLE FLOOD LAMP
2 - INSERT SMALL FLAT TOOL
COURTESY/READING LAMP
REMOVAL
(1) Insert a trim stick between the lamp bezel and
courtesy/readinglamp lens.
(2) Carefully swing down one side the lamp lens.
(3) Remove bulb from lamp socket.

INSTALLATION

(1) Push bulb in socket and snap into place.
(2) Position lens on lamp and snap into place.
DOME LAMP
REMOVAL
(1) Insert a trim stick between the lamp unit and
the lens.
(2) Carefully swing down one side the lamp lens.
(3) Remove lamp from lamp unit socket.
INSTALLATION
(1) Push lamp in socket and snap into place.
(2) Position lens on lamp unit and snap into place.
DOME LAMP UNIT
REMOVAL
(1) Insert a trim stick between the dome lamp unit
bezel and the headliner.
(2) Disconnect wire connector.
STACK
(3) Remove the dome lamp unit from vehicle.
INSTALLATION
(1) Place lamp into position.
(2) Connect electrical connector.
(3) Install dome lamp unit into headliner by firmly
pushing upward.
DOME LAMP WITH INTRUSION
SENSOR - EXPORT
REMOVAL
(1) Using suitable pry tool, gently pry open dome
lamp unit lens (Fig. 3).
(2) Remove dome lamp bulb from dome lamp.
Fig. 3 ACCESSING DOME LAMP
INSTALLATION
(1) Install dome lamp.
(2) Close dome lamp unit lens (Fig. 3).
DOME LAMP UNIT WITH
INTRUSION SENSOR -
EXPORT
REMOVAL
(1) Disconnect and isolate the negative battery
cable.
(2) Grasp the dome lamp unit with intrusion sen-
sor and rotate counterclockwise (Fig. 4).
PT