Chrysler PT Cruiser Service & Repair Manual page 473

PT
POWER FOLDAWAY MIRROR SWITCH - RHD (Continued)
RETRACTED MIRROR SWITCH CIRCUIT TEST
NOTE: MIRROR POSITION SWITCH MUST BE IN
THE "RETRACTED" POSITION TO USE CHART
BELOW.
WOBBLE LEFT MIRROR
PLATE SELECTED
POSITION
CONTINUITY
BETWEEN
↓
↑
→
←
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the lower instrument panel bezel from
under steering column.
(3) Remove the instrument panel end cover retain-
ing screws and pull rearward to release retaining
clips.
(4) Disconnect power mirror switch electrical con-
nector (Fig. 4).
(5) Remove the mirror switch retaining screws and
remove the switch from the end cover.
INSTALLATION
(1) Connect mirror switch electrical connector to
switch.
RIGHT
MIRROR
SELECTED
CONTINUITY
BETWEEN
PINS PINS
1, 3, 4, 9 3, 4, 6, 9
1, 3, 4, 9 3, 4, 6, 9
2, 3, 4, 9 3, 4, 7, 9
2, 3, 4, 9 3, 4, 7, 9
Fig. 4 RHD Power Mirror Switch Location
1 - POWER FOLDAWAY MIRROR SWITCH
(2) Install switch retaining screws holding switch
to end cover.
(3) Install the lower instrument panel bezel.
(4) Connect battery negative cable.
POWER MIRRORS 8N - 11