Installation; Satellite Receiver Module Description; Operation; Removal - Chrysler PT Cruiser Service & Repair Manual

PT
RADIO NOISE SUPPRESSION COMPONENTS (Continued)

INSTALLATION

ENGINE GROUND STRAP
(1) Install strap and bolt to strut tower. Tighten
bolt to 12 N·m (105 in. lbs.).
(2) Install strap and bolt to engine cylinder head.
Tighten bolt to 28 N·m (21 ft. lbs.).
(3) Connect battery negative cable.
HOOD HINGE GROUND STRAP
(1) Install strap and bolt to fender. Tighten bolt to
4 N·m (35 in. lbs.).
(2) Install strap and bolt to hood. Tighten bolt to 4
N·m (35 in. lbs.).
(3) Connect battery negative cable.
MUFFLER GROUND STRAP
(1) Install strap and bolt to rear floor pan. Tighten
bolt to 8 N·m (75 in. lbs.).
(2) Install strap and bolt to muffler. Tighten bolt to
8 N·m (75 in. lbs.).
(3) Connect battery negative cable.
RADIO NOISE SUPPRESSION CAPACITOR
(1) Install capacitor and bolt.
(2) Connect electrical harness connector to capaci-
tor.
(3) Connect battery negative cable.
STRUT BRACKET TO BODY GROUND STRAP
(1) Install strap to frame rail.
CAUTION: Ensure that ground strap does not come
in contact with brake hose. Damage to brake hose
can result.
(2) Install strap and bolt to strut. Tighten bolt to
12 N·m (105 in. lbs.).
(3) Connect battery negative cable.
SATELLITE RECEIVER
MODULE
DESCRIPTION
The satellite receiver module is located behind the
left rear trim panel. It is mounted to a bracket which
is fastened to the inner quarter panel sheet metal.

OPERATION

The satellite receiver module receives signals from
the roof mounted antenna and processes this infor-
mation before it is sent to the radio. The module
operates on both battery and accessory feed circuits
and will operate with the ignition key in the run or
accessory position only.

REMOVAL

(1) Disconnect and isolate the battery negative
cable.
(2) Remove the left rear quarter trim panel (Refer
to 23 - BODY/INTERIOR/LEFT QUARTER TRIM
PANEL - REMOVAL).
(3) Remove the mounting bracket fasteners (Fig.
16).
Fig. 16 SATELLITE RECEIVER MODULE
1 - SATELLITE RECEIVER MODULE
2 - MOUNTING BRACKET FASTENERS
(4) Disconnect the wire harness connectors.
(5) Remove the module from the mounting bracket.
INSTALLATION
(1) Position the module to the mounting bracket.
Tighten mounting fasteners to 6 N·m (53 in. lbs.).
(2) Connect wire harness connectors.
(3) Install mounting
Tighten to 5 N·m (45 in. lbs.).
(4) Install the left rear quarter trim panel (Refer
to 23 - BODY/INTERIOR/LEFT QUARTER TRIM
PANEL - INSTALLATION).
(5) Connect the battery negative cable.
SPEAKER
REMOVAL
FRONT DOOR SPEAKER
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the front door trim panel (Refer to 23 -
BODY/DOOR - FRONT/TRIM PANEL - REMOVAL).
(3) Remove the speaker retaining screws (Fig. 17).
(4) Remove speaker and disconnect wire harness
connector from speaker.
AUDIO 8A - 11
bracket and fasteners.