Table of Contents
Advertisement
LH
HEADLAMP WASHER NOZZLE
- EXPORT
REMOVAL
(1) Hoist vehicle.
(2) Partially remove the front fascia to gain access
to the headlamp assembly. Refer to Body for Removal
procedures.
(3) Remove the headlamp assembly. Refer to Elec-
trical, Lamps/Lighting - Exterior, Headlamp Unit,
Removal.
(4) Remove the headlamp washer nozzle retaining
screws and remove the nozzle from the headlamp
assembly (Fig. 5).
Fig. 5 HEADLAMP WASHER NOZZLE
1 - HEADLAMP WASHER NOZZLE
2 - HEADLAMP WASHER NOZZLE RETAINING SCREWS
3 - HEADLAMP ASSEMBLY
INSTALLATION
(1) Place the headlamp washer nozzle in position
on the headlamp assembly.
(2) Install the headlamp washer nozzle retaining
screws. Torque to 0.7 to 1.3 N·m.
(3) Reinstall the headlamp assembly. Electrical,
Lamps/Lighting - Exterior, Headlamp Unit, Installa-
tion.
(4) Reinstall the front fascia as necessary. Refer to
Body for Installation procedures.
(5) Lower vehicle from hoist.
(6) Refill the washer fluid.
(7) Prime the headlamp washer system. Refer to
the Electrical, Wipers/Washerr, Headlamp Washers,
Standard Procedures - Headlamp Washer System
Priming.
HEADLAMP WASHER PUMP -
EXPORT
REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the battery post.
(2) Hoist vehicle.
(3) Drain washer fluid into a clean container.
(4) Partially remove the front fascia to gain access
to the windshield/headlamp washer pump. Refer to
Body for Removal procedures.
(5) Remove the four windshield/headlamp washer
reservoir mounting bolts.
(6) Pull the reservoir away from body to gain
access to the headlamp washer pump (Fig. 6).
Fig. 6 HEADLAMP WASHER PUMP
1 - WINDSHIELD/HEADLAMP WASHER RESERVOIR
2 - HEADLAMP WASHER PUMP
(7) Disconnect the headlamp washer pump electri-
cal connector and the headlamp washer pump hose.
(8) Pull the headlamp washer pump from the res-
ervoir.
WIPERS/WASHERS 8R - 13
Advertisement
Chapters
Table of Contents
