Installation; Installation - 2.4L Turbo - Chrysler PT Cruiser Service & Repair Manual

8P - 8 SPEED CONTROL
SERVO (Continued)

INSTALLATION

INSTALLATION
(1) Install hairpin clip to servo and cable (Fig. 13).
(2) Install servo studs through cable bell and then
the bracket.
(3) Install nuts, tighten to 7 N·m (60 in. lbs.).
(4) Install speed control cable to throttle cam.
Refer to Speed Control Servo Cable Removal/Instal-
lation in this section.
(5) Connect electrical connector.
(6) Connect the vacuum hose to servo.
(7) Install the engine cover.
(8) Install the negative battery cable.
(9) Install the air cleaner lid, and makeup air
hose.

INSTALLATION - 2.4L TURBO

(1) Install the retaining clip holding cable to servo
(Fig. 11).
(2) Connect and lock the electrical connector to the
speed control servo (Fig. 10).
(3) Install the speed control servo to the mounting
bracket.
(4) Install the 2 nuts from the speed control servo
studs (Fig. 10).
(5) Install the vacuum line to the speed control
servo (Fig. 9).
(6) Install the speed control cable to the throttle
body lever.
(7) Install the throttle control shield (Fig. 7).
(8) Connect the negative battery cable.
SWITCH
REMOVAL
The speed control switches is mounted in the steer-
ing wheel and wired through the clock spring device
under the airbag module (Fig. 14).
Fig. 14 Speed Control Switch
WARNING: IF REMOVAL OF AIRBAG MODULE IS
NECESSARY, REFER TO THE RESTRAINT SYS-
TEMS.
(1) Remove the air cleaner lid, disconnect the inlet
air temperature sensor and makeup air hose.
(2) Remove the negative battery cable.
(3) Turn off ignition.
(4) Remove air bag, refer to the Restraint systems
section.
(5) Remove the top mounting screw (Fig. 15).
Fig. 15 Switch Top Mounting Screw
1 - TOP MOUNTING SCREW
(6) Rotate steering wheel so that the switch is in
the 6 o'clock position. Remove 2 screws from the back
side of the speed control switch.
(7) Disconnect the electrical connector.
(8) Remove switch (Fig. 16).
INSTALLATION
The speed control switch is mounted in the steer-
ing wheel and wired through the clock spring device
under the airbag module (Fig. 14).
WARNING: IF REMOVAL OF AIRBAG MODULE IS
NECESSARY, REFER TO THE RESTRAINT SYS-
TEMS.
(1) Connect the electrical connector.
(2) Install switch (Fig. 16) and tighten the screws
to 1.6 N·m (15 ins. lbs.). Make sure rubber seal is in
place around switch.
(3) Install airbag, refer to the Restraint Systems
section.
(4) Install the negative battery cable.
PT