Installation; Headlamp Leveling Motor - Export Description - Chrysler PT Cruiser Service & Repair Manual

PT
HEADLAMP UNIT (Continued)
Fig. 17 HEADLAMP UNIT HOUSING
1 - ATTACHING STUDS
2 - ATTACHING STUDS
3 - FRONT SIDE MARKER/TURN SIGNAL/PARK LAMP BULB
4 - LOW BEAM LAMP
5 - HIGH BEAM LAMP
Fig. 18 HEADLAMP UNIT REMOVAL
1 - FASCIA FASTENER
2 - FRONT FASCIA
3 - HEADLAMP UNIT

INSTALLATION

CAUTION: Do not touch the glass of halogen bulbs
with fingers or other possibly oily surface, reduced
bulb life will result.
(1) Connect wire connectors to the back of head-
lamp housing.
(2) Place headlamp housing in to position, lower
fascia as necessary to install headlamp housing in to
position (Fig. 19) and (Fig. 18). Tilt headlamp unit to
opening as necessary.
LAMPS/LIGHTING - EXTERIOR
Fig. 19 HEADLAMP UNIT REMOVAL
1 - MOUNTING HOLES
2 - FRONT SIDE MARKER/PARK/TURN SIGNAL LAMP
3 - MOUNTING HOLES
4 - HEADLAMP HOUSING
5 - LOW BEAM CONNECTOR
6 - MOUNTING HOLE
7 - HIGH BEAM CONNECTOR
(3) Install nut(s) attaching headlamp housing (Fig.
17).
(4) Test lamp operation.
(5) Install fasteners attaching fender to fascia on
the side being work on.
(6) Install the two fascia bolts from behind the
grille (Fig. 15) and (Fig. 16).
(7) Install three fasteners to hold the lower fascia
to the lower radiator crossmember.
(8) Install grille.
(9) Install splash shield as necessary to access
headlamp housing.
(10) Install wheel and tire.
(11) Lower vehicle.
HEADLAMP LEVELING MOTOR
- EXPORT
DESCRIPTION
The Headlamp Leveling System allows the driver
to adjust the headlamp beam pattern from the inte-
rior of the vehicle to compensate for passenger or
cargo load. Only the vertical axis of the headlamp
beam can be adjusted.
A headlamp leveling switch is located on the
instrument panel and controls the headlamp leveling
motors found on the headlamp unit. The headlamp
leveling switch has four settings 0-3, 0 being the low-
8L - 15