Removal - 2.2 Diesel - Chrysler PT Cruiser Service & Repair Manual

PT
STARTER MOTOR (Continued)
(7) Push up the spring clip that holds the heat
shield for the starter (Fig. 5).
Fig. 5 STARTER HEAT SHIELD
(8) Remove the upper mounting bolts first.
(9) Remove the lower mounting bolt.
(10) Remove the starter through the wheel well
(Fig. 6).
Fig. 6 STARTER REMOVAL

REMOVAL - 2.2 DIESEL

(1) Disconnect the negative battery cable.
(2) Remove the front grill, refer to the Body sec-
tion for more information.
(3) Remove the hood seal, refer to the Body section
for more information.
(4) Remove the upper radiator crossmember.
(5) Remove ambient temperature sensor.
(6) Raise vehicle and support.
(7) Drain radiator, refer to the Cooling section for
more information.
(8) Disconnect the electrical connector for the radi-
ator fan.
(9) Remove the underbody plate (skid plate), refer
to the Body section for more information.
(10) Remove the lower radiator hose.
(11) Remove the 2 lower bolts for the inner cooler
mounting to radiator.
(12) Lower vehicle.
(13) Remove the upper radiator hose.
(14) Remove the 4 upper bolts for the inner cooler
mounting to radiator.
(15) Remove inner cooler from radiator by lifting
the inner cooler up off of the 2 lower mounting tabs
(Fig. 7)and push it toward the front of vehicle. These
tabs are on the bottom of the inner cooler and lock
into the bottom of the radiator.
Fig. 7 MOUNTING TABS
STARTING 8F - 41