Center Console Flood Lamp Removal; Installation; Center Console Flood Lamp Housing Removal - Chrysler PT Cruiser Service & Repair Manual

PT
LAMPS/LIGHTING - INTERIOR (Continued)
BULB
MALFUNCTION
INDICATOR LIGHT
MAP/READING
LAMP
REAR CARGO
LAMP
SEAT BELT
INDICATOR
SECURITY ALARM
INDICATOR
TRAC OFF
INDICATOR
TURN SIGNAL
INDICATOR
VISOR VANITY
VOLTAGE
INDICATOR
All the interior bulbs utilize a brass or glass wedge
base. Bulbs with aluminum bases are not approved
and should not be used.
CENTER CONSOLE FLOOD
LAMP
REMOVAL
(1) Open hood.
(2) Disconnect and isolate the battery negative
cable.
(3) Insert a small screwdriver into notch by clip
(Fig. 1)and gently pry out unit.
(4) Slide back rear cover to expose bulb.
(5) Replace bulb.

INSTALLATION

(1) Insert new bulb.
(2) Gently secure bulb back into slot.
NOTE: When installing the retainer, ensure that the
forward tabs are inserted properly into the slots in
the instrument panel.
(3) Connect the battery negative cable.
(4) Close hood.
(5) Verify vehicle and system operation.
CANDLE
LAMP
POWER
LED
T1037 4.4
T904 4.0
LED
LED
LED
T74 0.7
6501966 4.4
LED
LAMPS/LIGHTING - INTERIOR
Fig. 1 CENTER CONSOLE FLOOD LAMP LOCATION
1 - CENTER CONSOLE FLOOD LAMP
CENTER CONSOLE FLOOD
LAMP HOUSING
REMOVAL
(1) Using a flat blade tool, remove console flood
lamp from the lower center console (Fig. 2).
(2) Disconnect wire connector.
(3) Remove console flood lamp housing.
INSTALLATION
(1) Place console flood lamp housing near opening
and connect the wire connector (Fig. 2).
(2) Test lamp.
(3) Place console flood lamp into position and
apply hand pressure to snap lamp into position.
8L - 29