Removal; Installation - Chrysler PT Cruiser Service & Repair Manual

PT
POWER SEAT TRACK (Continued)
cavity of the power seat wire harness connector for
the power seat switch. If OK, go to Step 3. If not OK,
repair the open fused B(+) circuit between the power
seat switch and the JB as required.
(3) Check for continuity between the ground cir-
cuit cavity of the power seat wire harness connector
for the power seat switch and a good ground. There
should be continuity. If OK, Step 4. If not OK, repair
the open ground circuit to ground as required.
(4) Test the power seat switch. If the switch tests
OK, test the circuits of the power seat wire harness
for the inoperative power seat motor(s) between the
power seat switch and the inoperative motor for
shorts or opens. If the circuits check OK, replace the
faulty power seat track. If the circuits are not OK,
repair the power seat wire harness as required.

REMOVAL

(1) Remove the power seat from the vehicle and
set face down on a clean surface. (Refer to 23 -
BODY/SEATS/SEAT - REMOVAL)
Fig. 4 SEAT FRONT RISER REMOVAL/

INSTALLATION

(2) Remove the bolts retaining the front riser and
set the front seat riser aside (Fig. 4).
(3) Remove the bolts retaining the rear riser (Fig.
5) and set the seat riser aside.
(4) Remove the lower seat track cover screws and
set it aside.
POWER SEAT SYSTEM
Fig. 5 POWER SEAT TRACK
1 - Power Seat Track
2 - Lower Seat Track Cover
3 - Rear Seat Cushion Riser
(5) Remove the seat cushion side shields and set
aside.
(6) Disengage and disconnect the power seat wire
harness from the power seat track.
(7) Remove the power seat track retaining fasten-
ers and remove the power seat track from the seat.
INSTALLATION
(1) Reinstall the power seat track onto the seat
cushion frame. Torque bolts to 21 ft. lbs. (28 N·m).
(2) Secure and connect the power seat wire har-
ness on the power seat track.
(3) Install the seat cushion side shields.
(4) Install the lower seat track cover.
(5) Install the bolts retaining the rear riser. Torque
bolts to 21 ft. lbs. (28 N·m).
(6) Install the bolts retaining the front riser.
Torque bolts to 21 ft. lbs. (28 N·m).
(7) Reinstall the power seat assembly into the
vehicle as a unit. (Refer to 23 - BODY/SEATS/SEAT -
INSTALLATION). Torque bolts to 45 ft. lbs. (61 N·m).
(8) Reconnect the battery negative cable.
8N - 15