Power Window Switch - Chrysler PT Cruiser Service & Repair Manual

8N - 18 POWER WINDOWS
POWER WINDOWS (Continued)
will grunt and the inner door panel will flex when
actuated in that one direction.
(6) Reverse jumper probes at the motor connector
terminals and window should now move in opposite
direction. If window does not move or grunt, replace
the motor.
If window moved completely up or down, reverse
the jumper probes and cycle window to the opposite
position to verify full operation.
If motor grunts and does not move, verify that reg-
ulator is not binding.

POWER WINDOW SWITCH

DIAGNOSIS AND TESTING - POWER WINDOW
SWITCH
Remove the switch. Using an ohmmeter, test the
window switch for continuity in all positions listed in
the Continuity Table. Refer to the Power Window
Switch Continuity table to determine if continuity is
correct (Fig. 1) and (Fig. 2).
Fig. 1 FRONT WINDOW SWITCH
Fig. 2 REAR WINDOW SWITCHES
1 - RIGHT REAR SWITCH
2 - LEFT REAR SWITCH
POWER WINDOW SWITCH CONTINUITY
SWITCH POSITION
LOCKOUT SWITCH
(TOP OF SWITCH
DEPRESSED)
LEFT FRONT UP
RIGHT FRONT UP
LEFT REAR UP
LEFT REAR DOWN
RIGHT REAR UP
RIGHT REAR DOWN
OFF
UP
DOWN
To test the left front down and express down
switch position, connect pin 4 to ground and pin 12
to a 12 volt source. Using a voltmeter, measure for
voltage from pin 13 to ground.
To test the right front down and express down
switch position, connect pin 4 to ground and pin 12
to a 12 volt source. Using a voltmeter, measure for
voltage from pin 3 to ground. If the correct results
are not obtained, replace the switch.
TABLE
CONTINUITY BETWEEN
FRONT WINDOW
SWITCH
PIN 12 AND 5
PIN 12 AND 14
PIN 12 AND 7
PIN 12 AND 8
PIN 12 AND 9
PIN 12 AND 1
PIN 12 AND 2
LEFT OR RIGHT REAR
SWITCH
PIN 2 AND 5
PIN 3 AND 8
PIN 4 AND 5
PIN 4 AND 8
PT