Chrysler PT Cruiser Service & Repair Manual page 472

8N - 10 POWER MIRRORS
POWER MIRROR SWITCH - LHD (Continued)
Fig. 2 Power Mirror Switch Remove/Install
(6) Roll bezel upward and snap into place.
(7) Connect the battery negative cable.
POWER FOLDAWAY MIRROR
SWITCH - RHD
DIAGNOSIS AND TESTING - POWER
FOLDAWAY MIRROR SWITCH - RHD
The following test is designed to be used only on
vehicles equipped with power fold-away side view
mirrors.
(1) Remove power mirror switch from mounting
position (Refer to 8 - ELECTRICAL/POWER MIR-
RORS/POWER FOLDAWAY MIRROR SWITCH -
REMOVAL).
(2) Using an ohmmeter, test for continuity between
the terminals of the switch as shown in the tables
below (Fig. 3).
NOTE: When testing using the chart below be cer-
tain to read the chart correctly. Example - When
testing left mirror "DOWN↓", pins 1, 9, 10 will show
continuity to each other but not with 3, 4, 5.
(3) If test results are not obtained as shown in the
tables below, replace the switch.
EXTENDED MIRROR SWITCH CIRCUIT TEST
NOTE: MIRROR POSITION SWITCH MUST BE IN
THE "EXTENDED" POSITION TO USE CHART
BELOW.
Fig. 3 Power Fold-Away Mirror Switch
WOBBLE LEFT MIRROR
PLATE SELECTED
POSITION
CONTINUITY
BETWEEN
PINS
↓
1, 9, 10
3, 4, 5
↑
1, 4, 5
3, 9, 10
→
2, 9, 10
3, 4, 5
←
2, 4, 5
3, 9, 10
PT
RIGHT
MIRROR
SELECTED
CONTINUITY
BETWEEN
PINS
6, 9, 10
3, 4, 5
6, 4, 5
3, 9, 10
7, 9, 10
3, 4, 5
7, 4, 5
3, 9, 10