Installation; Liftgate Cylinder Lock Switch Removal - Chrysler PT Cruiser Service & Repair Manual

8Q - 6 VEHICLE THEFT SECURITY
INTRUSION SENSOR - EXPORT (Continued)
Fig. 5 DOME LAMP UNIT WITH INTRUSION SENSOR
REMOVAL
(5) Remove the dome lamp unit with intrusion
sensor from the vehicle.

INSTALLATION

(1) Connect electrical connector.
(2) Orient the dome lamp unit with intrusion sen-
sor in a way that the tabs align with the slots in the
headliner (Fig. 6).
Fig. 6 DOME LAMP UNIT WITH INTRUSION SENSOR
ORIENTATION TO HEADLINER
(3) Push the dome lamp unit with intrusion sensor
straight up.
(4) Rotate the dome lamp unit with intrusion sen-
sor clockwise.
(5) Connect the battery negative cable.
LIFTGATE CYLINDER LOCK
SWITCH
REMOVAL
(1) Open hood.
(2) Disconnect and isolate the battery negative
cable (Fig. 1).
(3) Remove the liftgate trim panel (Refer to 23 -
BODY/DECKLID/HATCH/LIFTGATE/TAILGATE/
TRIM PANEL - REMOVAL).
(4) Remove the liftgate cylinder U-bracket by slid-
ing it out.
(5) Remove switch E-clip and disconnect connector.
(6) Remove liftgate cylinder lock switch from lift-
gate lock cylinder (Fig. 7) by gently unsnapping.
Fig. 7 LIFTGATE CYLINDER LOCK SWITCH
LOCATION
1 - LIFTGATE CYLINDER LOCK SWITCH
2 - LIFTGATE LOCK MOTOR
3 - LATCH ASSEMBLY
4 - LIFTGATE AJAR SWITCH
INSTALLATION
(1) Install liftgate cylinder lock switch on rear of
liftgate lock cylinder without rotating the switch
(Fig. 2).
(2) Install the liftgate cylinder U-bracket by slid-
ing it in.
(3) Install switch E-clip and connector.
PT