Installation - 2.4L Turbo; Speed Control; Servo Description - Chrysler PT Cruiser Service & Repair Manual

8P - 6

SPEED CONTROL

CABLE (Continued)
Fig. 9 VACUUM AND ELECTRICAL CONNECTION
1 - Electrical Connector
2 - Vacuum Line and Nipple
Fig. 10 SPEED CONTROL SERVO - 2.4L TURBO
(3) Slide cable bell housing over servo mounting
studs through the bracket.
(4) Install 2 nuts, tighten to 7 N·m (60 ins. lbs.).
(5) Slide cables into throttle cable bracket and
engage retaining tabs (Fig. 4).
(6) Rotate the throttle cam forward to the wide
open position and install speed control cable clasp
(Fig. 4).
(7) Rotate the throttle cam forward to the wide
open position and install throttle cable clasp.
(8) Install engine cover and throttle control shield,
if equipped.
(9) Install the negative battery cable.
Fig. 11 Cable Clip
1 - HAIRPIN CLIP
(10) Install the air cleaner lid, makeup air hose.

INSTALLATION - 2.4L TURBO

(1) Install the cable.
(2) Install the retaining clip holding cable to servo
(Fig. 11).
(3) Connect and Lock the electrical connector to
the speed control servo (Fig. 9).
(4) Install the speed control servo to the mounting
bracket.
(5) Install the 2 nuts to the speed control servo
studs (Fig. 10) and tighten to 7 N·m(60 in. lbs.).
(6) Install the vacuum line to the speed control
servo nipple (Fig. 9).
(7) Install speed control cable to throttle cable
bracket (Fig. 8).
(8) Install the speed control cable to the throttle
body lever.
(9) Install the throttle control shield (Fig. 7).
(10) Connect the negative battery cable.
SERVO
DESCRIPTION
The servo unit consists of a solenoid valve body,
and a vacuum chamber. The solenoid valve body con-
tains three solenoids:
• Vacuum
• Vent
• Dump
The vacuum chamber contains a diaphragm with a
cable attached to control the throttle linkage.
PT