Removal; Installation; Fog Lamp Unit; Standard Procedure - Fog Lamp Unit Alignment - Chrysler PT Cruiser Service & Repair Manual

8L - 8

LAMPS/LIGHTING - EXTERIOR

FOG LAMP (Continued)
CONDITION
FOG LAMPS DO NOT
ILLUMINATE

REMOVAL

(1) Reach behind the lower splash shield to gain
access to the rear of the fog lamp (Fig. 9).
(2) Disconnect wire connector from fog lamp.
(3) Remove bulb from lamp.
Fig. 9 FOG LAMP
1 - FOG LAMP ADAPTER
2 - FOG LAMP BULB
3 - FRONT FASCIA

INSTALLATION

CAUTION: Do not touch the glass of halogen bulbs
with fingers or other possibly oily surface, reduced
bulb life will result.
(1) Install bulb into lamp (Fig. 9).
(2) Connect wire connector to the fog lamp.
Test operation of lamp.
(3) Install splash shield attaching fasteners.
POSSIBLE CAUSES
1. Blown fuse for fog lamp.
2. No Z1-ground at fog lamps.
3. Faulty fog lamp switch.
4. Broken connector terminal or wire
splice in fog lamp circuit.
5. Defective or burned out bulb.
1. Replace fuse. Refer to Wiring Diagnosis.
2. Repair circuit ground. Refer to Wiring
Diagnosis.
3. Replace fog lamp switch.
4. Repair connector terminal or wire splice.
5. Replace bulb.

FOG LAMP UNIT

STANDARD PROCEDURE - FOG LAMP UNIT
ALIGNMENT
Prepare an alignment screen (Refer to 8 - ELEC-
TRICAL/LAMPS/LIGHTING
LAMP UNIT - STANDARD PROCEDURE) and read
the Alignment Screen Preparation paragraph. Turn
on the headlamp switch to the parking lamps only
position and actuate the fog lamp switch. A properly
aligned fog lamp will project a pattern on the align-
ment screen with the top of the cut-off line 10 cm (4
in.) below the fog lamp center line and straight
ahead with the vehicle 25 feet from the alignment
screen.
To adjust fog lamp unit alignment, rotate the align-
ment screw located on the side of the fog lamp unit
from the cooling opening in the fascia, just inboard of
the fog lamp opening, to achieve the specified pattern
position (Fig. 10).
REMOVAL
(1) Remove fasteners attaching lower splash shield
to gain access to the rear of the fog lamp (Fig. 9).
(2) Disconnect wire connector from fog lamp.
(3) Remove nuts attaching fog lamp to fascia.
(4) Remove lamp from fascia. The lower horn may
need to be removed for easier fog lamp unit removal.
(5) Remove the two fasteners attaching the out-
board end of the fascia to the fender.
(6) Rotate fog lamp unit forward, up, and out.
INSTALLATION
CAUTION: Do not touch the glass of halogen bulbs
with fingers or other possibly oily surface, reduced
bulb life will result.
(1) Rotate fog lamp unit into position.
(2) Place fog lamp unit into position.
(3) Ensure that the three locating tabs molded into
the fog lamp adapter are seated in the three match-
ing fascia slots.
(4) Install nuts attaching fog lamp to fascia.
CORRECTION
- EXTERIOR/HEAD-
PT