Adjustment - Brake Lamp Switch; Center High Mounted Stop Lamp Removal - Chrysler Concorde 2004 Service Manual

LH
BRAKE LAMP SWITCH (Continued)
Fig. 4 BRAKE PEDAL AND BRAKE LAMP SWITCH
1 - BUSHINGS
2 - BRAKE PEDAL
3 - BRAKE LAMP SWITCH
4 - PIVOT SHAFT
(3) Mount the brake lamp switch into the bracket
as follows: Depress the brake pedal as far down as
possible. Install the switch in it's bracket by aligning
the index key on switch with the notch in the square
mounting hole of the mounting bracket (Fig. 4). Once
the switch is fully seated, rotate the switch clockwise
approximately 30° to lock the switch into the bracket.
CAUTION: Do not use excessive force when pulling
back on the brake pedal to adjust the brake lamp
switch. If to much force is used, damage to the
brake lamp switch or striker can result.
(4) Gently pull back on brake pedal until the pedal
stops moving. This will cause the switch plunger to
ratchet backward to the correct position.
(5) Check for proper operation of the brake lamps
and speed control.
ADJUSTMENTS

ADJUSTMENT - BRAKE LAMP SWITCH

(1) Depress and hold the brake pedal.
(2) Remove the brake switch from it's bracket (Fig.
4). To do so, rotate the brake lamp switch in a coun-
terclockwise direction approximately 30 degrees from
its proper mounting position. Pull the switch rear-
ward and remove it from it's mounting bracket.
(3) Hold the brake lamp switch firmly in one hand.
Using your other hand, pull outward on the plunger
of the switch until it has ratcheted out to its fully
extended position.
LAMPS/LIGHTING - EXTERIOR 8L - 7
(4) Mount the brake lamp switch into the bracket
as follows: Depress the brake pedal as far down as
possible. Install the switch in it's bracket by aligning
the index key on switch with the notch in the square
mounting hole of the mounting bracket (Fig. 4). Once
the switch is fully seated, rotate the switch clockwise
approximately 30° to lock the switch into the bracket.
CAUTION: Do not use excessive force when pulling
back on the brake pedal to adjust the brake lamp
switch. If to much force is used, damage to the
brake lamp switch or striker can result.
(5) Gently pull back on brake pedal until the pedal
stops moving. This will cause the switch plunger to
ratchet backward to the correct position.
(6) Check for proper operation of the brake lamps
and speed control.
CENTER HIGH MOUNTED
STOP LAMP
REMOVAL
CONCORDE
(1) Open hood, disconnect and isolate the battery
negative cable.
(2) Release decklid latch and open decklid.
(3) From under rear shelf panel, disconnect the
lamp socket from the CHMSL housing (Fig. 5).
(4) Remove bulb from the socket.
Fig. 5 CHMSL - REAR SHELF
1 - CHMSL HOUSING
INTREPID
(1) Open hood, disconnect and isolate the battery
negative cable.
(2) Release decklid latch and open decklid.
(3) Remove decklid cover.