Removal And Installation Ash Receiver Retainer And Lamp; Center Bezel; Cigar Lighter Receptacle; Cluster Lamp - Chrysler neon 1997 Service Manual

ILLUM ABS H/B T/S S/B T/S
8E - 8 INSTRUMENT PANEL AND SYSTEMS
REMOVAL AND INSTALLATION
ASH RECEIVER RETAINER AND LAMP
REMOVAL
(1) Remove the ash receiver receptacle.
(2) Remove the center bezel.
(3) Remove the two ash receiver retainer attaching
screws from the upper-rearward face and remove
retainer.
(4) For lamp replacement, remove the clamp and
lamp hood from the top of the retainer. Remove the
wiring clip at the forward edge of the retainer and
remove the lamp socket from the hood and replace
lamp.
INSTALLATION
For installation reverse the above procedures.
When installing the retainer ensure that the forward
tabs are inserted properly into the slots in the instru-
ment panel.

CENTER BEZEL

REMOVAL
(1) Open the ash receiver receptacle.
(2) Grasp the bezel and pull rearward disengaging
the clips.
INSTALLATION
For installation, reverse the above procedures.

CIGAR LIGHTER RECEPTACLE

REMOVAL
(1) Remove the cigar lighter element.
AIR BAG HAZARD ILLUM
Fig. 16 Instrument Cluster Illumination Lamps
OIL BRAKE BATT
ILLUM
(2) Reach underneath
through the bottom access hole and disconnect the
cigar lighter receptacle wiring connectors.
(3) Unscrew the cigar lighter receptacle shell from
the receptacle and remove from the base instrument
panel.
INSTALLATION
For installation, reverse the above procedures.
CLUSTER
CAUTION: Cluster MUST be stored in a face up
position or damage will occur to the gauge opera-
tion.
REMOVAL
(1) Disconnect the battery to ensure no DTCs are
generated.
(2) Remove the instrument panel top cover and
cluster bezel.
(3) Remove the four screws attaching cluster hous-
ing to the base panel.
(4) Pull the cluster rearward to disconnect from
base panel.
(5) Remove the cluster assembly.
INSTALLATION
For installation, reverse the above procedures.

CLUSTER LAMP

The Instrument Cluster illumination Lamps loca-
tion are shown in (Fig. 16). The cluster is viewed
from the rear. To replace lamp(s), the cluster must be
removed. Refer to Cluster Removal and Installation
procedure.
ILLUM (OPT) ILLUM
(OPT) CHK ENG
LOW FUEL
the instrument
PL
panel