Radiator And Oil Cooler; Chapter Overview; Personal Safety; Machine Preparation - Terex PT-100G Forestry Service Manual

Chapter Overview

This chapter provides information on the disassembly
and assembly of the radiator/oil cooler and associated
components. If there is an issue that requires
troubleshooting, refer to chapter 18, Troubleshooting.

Personal Safety

Improper or incomplete maintenance/repair of a Compact
Track Loader can be dangerous and may result in machine
damage, injury or death.
Do not attempt to perform any type of repair or maintenance
on a Compact Track Loader until you have read and fully
understood the information in this manual. Refer to the
Operation and Maintenance manual for instructions
regarding proper machine operation techniques before
operating any Compact Track Loader.
Prior to performing any type of service work on a Compact
Track Loader, read and understand Chapter 1 (Product
Safety) for personal safety information.

Machine Preparation

Accidental machine starting can cause injury or death to
personnel working on a Compact Track Loader.
As a precaution, disconnect the battery cables from the
battery terminals, tape the battery clamps and remove the
key from the ignition switch prior to performing any service
work on a Compact Track Loader.
Place a "Do Not Operate" tag prominently on the machine to
inform personnel that the machine is being worked on.

8. Radiator and Oil Cooler

Removal and Installation
Removal and installation procedures are provided for
the following radiator/oil cooler components.

Fan Guard

Fan
•
Radiator/Oil Cooler/Fan Shroud
•
•
Note: Procedures are provided for only those radiator/oil
cooler components listed above. However, exploded parts
diagrams exist in the PT-100G Parts manuals to serve as
visual aids in the assembly and disassembly of other system
components.
Note: Refer to pages 3-1 and 3-2 for pictorial views of the
filtering and cooling system components.
Fan Guard
Removal
Required Tools
Combination Wrench
Socket Wrench
Socket Wrench Extension (optional)
8-1
1. Remove key to avoid accidental start and then
remove the bolts (4) that secure the fan guard to
fan shroud (fig. 8-1).
8-1