Front And Rear Axles - Terex PT-100G Forestry Service Manual

Front and Real Axles
Removal
Required Tools
Socket/impact wrench
Heavy duty hydraulic jack
Combination wrench
Terex approved jack stands (2)
Shop vac or Pressure washer
Note: The front and rear axles may be removed from
the chassis while leaving the suspension components
intact.
1. Suspend machine from the ground as described in
jacking procedure on page 4-2 using Terex
approved jack stands.
13-52
2. Remove the three bolts that secure the suspen-
sion mount bracket to the front axle (fig. 13-52).
13-53
3. Remove the two bolts that secure the suspension
retaining plate to the rear axle (fig. 13-53).
13-54
4. Remove the four bolts that secure the drive hose
guides located on both the right and left sides of
the chassis (fig. 13-54).
13-55
5. Support each undercarriage with a suitable lifting
device, then slide each of the undercarriages out-
ward and off of the axles (fig. 13-55).
13-56
6. Support the axle with a suitable lifting device (as
shown), then remove the four bolts that secure
front and rear axles to each side of the chassis
(fig. 13-56).
Note: Always place the jack beneath the center of the
axle.
13-11
Compact Track Loader
13. Undercarriage
jack placement