Idler Hub - Terex PT-100G Forestry Service Manual

Compact Track Loader
13. Undercarriage
13-24

Idler Hub

Service Procedure
Required Tools
Press & Tool Kit ( 0403-339)
Socket Wrench & Sockets (including Allen)
Snap Ring Pliers
1. Remove the hub assemblies from the
undercarriages as required first by following steps
1-7 of the track removal procedure on page 4-6.
Then proceed to the steps below.
2. Remove the snap ring (item 25) securing the cap
(item 24) in the hub assembly (fig. 13-24).
3. Remove the nut (item 23) and the washer (item
22), then remove the hub assembly from the axle
shaft (fig. 13-24). (see note below)
Axle
13-25
Note: If you are removing the inner front hub
assembly, you will have to slide the axle (item 41) out
of the main rail weldment to remove it
(fig. 13-24, 13-25).
Note: If you are removing the outer or rear hub
assemblies you will be able to remove the hub
assembly once step three is complete.
13-26
13-27
4. Using a press and tool part # 0403-336, press the
bearing sleeve out of the hub assembly
(fig. 13-26, 13-27).
13-6
0403-339
Hub Tool Kits
Part #: 0403-336