Hydraulic Oil Cooler - Terex TL80 Operating Instructions Manual

7 Maintenance and Care

7.9.10 Hydraulic oil cooler

Dirt accumulation in coolers causes the
hydraulic
Only perform cleaning after stopping the
engine and letting it cool down
The machine is equipped with a combined radiator
and hydraulic oil cooler. Both cooler components
must be cleaned during maintenance (see also
Chap. 7.9.3)
• Clean the cooler components (52/1) by blowing
it out with compressed air from the air
discharge side.
If necessary, clean with cold cleaner or
steam jet device with oil separator over a
suitable surface. Do not spray generator
directly with water or jet stream while
doing so.
Run engine hot afterward to prevent
formation of rust.
88
oil to overheat.
Fig. 52 Hydraulic oil cooler
1
L824-037
TL80