Terex PT-100G Forestry Service Manual page 89

13-40
16. Once the seals are in place, wipe the mating
surfaces of the face seals with a clean shop cloth
and alcohol in a circular motion ending in a gentle
sweep from the inside to the outside of the face
until clear of the face.This will ensure a clean
mating surface and a good seal (fig. 13-39, 13-40).
13-41
17. Apply a very thin coating of fresh 10W30 engine
oil onto the now clean seal faces (faces only) in a
circular motion (fig. 13-41).
13-42
18. Press the bearing sleeve assembly (with face seal
clean, installed, and oiled) into the hub with tool
0403-336 until seated (fig. 13-42).
13-43
19. Flip the hub over, support the bearing sleeve from
the bottom with tool 0403-335 and set it onto the
press for center seal installation (fig. 13-43).
13-44
20. Install the center seal into the hub. Work the lip
around the bearing sleeve with your fingers prior
to pressing it into place (fig. 13-44).
13-45
21. Install the race into the hub as shown above the
seal. When the race is pressed into place, it will
push the seal into position (fig. 13-45).
Note: See step 22 for tool information and race
installation instructions.
13-9
Compact Track Loader
13. Undercarriage
Part #: 0403-335